I setup & Midi the unit with my E60 KB no prob.....I set the FX reverb to my needs eg: hall......all works great.....

Then I'll play a few chords and stop and for some unknown reason I lose the reverb that I setup.....if I just turn the FX knob a little it returns ....but the same thing happens over & over again I need it to stay with the reverb I set up......any clues?

donny

Hi Donny,

Just make sure its not the E60 sending a default CC 91(rev) which resets rev to 0. Or a preset level that is embedded as saved data in a style/smf and which will also alter the rev setting you have on the harmony m.

Remember its only the harmony m receiving (RX) channel you need to remove/block it from, as the harmony m receives on one channel only.

Although its probably better to block all transmission of CC's, particularly as you don't use an external sound module/keyboard.

If I remember correctly you can edit one of the "Midi Setups" to block transmission (TX) of the CC data, and this can be set to the default setup at E60 startup.

Dennis

Dennis I will look into that for sure ...I also have TC helicon support involved waiting for an answer shortly.

Okay Donny, cool..

Being an owner of the harmony M as well, I will follow with interest how it resolves..

Dennis

Ok now its working correctly it seems the computer needs to analyze my playing & singing and sync it up together......so after a few songs its now working like it did previously on my other KB.....

Im still awaiting an official answer from TC Electronics too....stay tunes and thanks for your help.

Be sure you disable Control Change commands on the Harmony M. Manual tells you how.
DonM

Thanks Don that is exactly what was the problem......once I went into MIDI mode & disabled the CC reception commands everything is fine again Whew!!
Instructions are on Page 20 of the manual under Advanced users Midi Setup.

The first thing to do is to perform a master reset. This is done by holding down he Manual and Voice2 buttons for 3 seconds while plugging in the power cord. The Harmony will boot normally after the memory is initialized.

Also, did you set the midi channel correctly for the new keyboard--this is important. This is done by holding down the A/B and On buttons until the lights begin flashing, then play a "C" chord on the keyboard. Then press the On button a couple times until the lights stop flashing.

The program Change Receive On/Off should be turned off, which is done via the Tone button. When the tone button is lit the Harmony M can receive program changes from the keyboard.

Gary

Thank You Mr Wizard all is well now you have explained the remedy completely as usual