In performance mode on the jv 1080, can you set individual fx settings for each of the 16 patches(hall 2 reverb on track 1, stage 2 reverb on track 2, distortion on track 3 etc.)? If you can, how do you save the fx settings for each patch? Every time I make settings I hit the utility button, then enter twice, then the utility button again to save them, but, when I turn the 1080 off, then back on, my parameters have changed. Thanks for any advice. - merriphew

Hi

You can not use different effect-settings for different parts in a multi-timbral performance. The JV1080 "only" has 3 effect-processors: Reverb, Chorus and EFX. The only thing you can adjust for each part, is how much the part shuold send to each processor. The settings for each of the processors are global.

Stig

settings for each of the 16 patches(hall 2 reverb on track 1, stage 2 reverb on track 2, distortion on track 3 etc.)?

When you selected stage 2 on track 2, you changed track 1 to stage 2 from your previous hall 2.

These are a bit confusing.