domenico,
on VSTHOST manual page 26 is written:
Here, you can select one of the 129 possible performances in the current bank (see “Use Bank…”
above).
This operation can also be performed by sending a Program Change MIDI message to the Remote
Control Channel, with one exception: performance 000 is a special program; this cannot be selected by
remote operation. Unless Reload Performance is checked on the File menu, VSTHost loads this
performance as its initial setup. This way, you can define a nice default environment.
A performance’s initial name is “** Init **” – not very inventive, I have to admit – and can be
changed if you save it with Save As… (described below).
The Up and Down buttons can be used to reposition the selected performance in the current bank.
Note: this action takes place immediately; it can not be undone by pressing the Cancel button.
http://www.hermannseib.com/documents/VSTHost.pdf so, when I read i think we most save like this:
vsthost1.exe
000. ** Init ** (do not change this)
001. your VST name1
but on VSTHOSt you have written like this:
vsthost1.exe
000. your VST name1
001. ** Init **
vsthost2.exe
000. your VST name1
001. ** Init **
vsthost3.exe
000. your VST name1
001. ** Init **
and...................
has this no consequences?
[This message has been edited by AFG Music (edited 04-22-2010).]