SYNTH ZONE
Visit The Bar For Casual Discussion
Page 1 of 3 1 2 3 >
Topic Options
#379721 - 12/28/13 10:15 PM Help. S950 compressor for talk settings
Beakybird Offline
Senior Member

Registered: 01/27/01
Posts: 2227
I often tell little one liners before songs that get people laughing, but about once a month I get a section of the audience (it's almost always on my left side) who say they hear me when I sing, but they cannot hear my jokes.

I thought that there was nothing I could do about this outside of trying a different sound system or getting a different mic. I use two FBT Maxx 2A's on the floor tilted up towards the audience and the Crowne CM311A mic. Ok, I know that it would be better for the speakers to be on stands, but I am doing hundreds of relatively low paying gigs, and I want to save on setup time.

It occurred to me that maybe by turning on the compressor in the talk settings of my PSR-S950 could help. For those who are familiar with the S950 or familiar with compressors, what would be a good setting for public speaking that might solve this problem? Thanks!

Top
#379723 - 12/28/13 11:42 PM Re: Help. S950 compressor for talk settings [Re: Beakybird]
Mark79100 Offline
Senior Member

Registered: 10/23/06
Posts: 1661
Loc: USA
I used to get that problem every so often. They couldn't understand me only when I talk. My own solution was simple.......move my mouth back from the mike to the furthest point where the mike will still pick up my voice. Depending on the mike you use, it actually takes a bit of conscious effort to remember to stay in that "clear" zone.

Mark

Top
#379750 - 12/29/13 06:42 AM Re: Help. S950 compressor for talk settings [Re: Mark79100]
Beakybird Offline
Senior Member

Registered: 01/27/01
Posts: 2227
Originally Posted By: Mark79100
I used to get that problem every so often. They couldn't understand me only when I talk. My own solution was simple.......move my mouth back from the mike to the furthest point where the mike will still pick up my voice. Depending on the mike you use, it actually takes a bit of conscious effort to remember to stay in that "clear" zone.

Mark


My mic is a headset mic. This is not possible. The Yamaha S950 and some other Yamaha models come with a compressor and a noise gate in the Talk settings menu. I have both of these switched to off. I wanted to find out what compression settings might help with this problem. Thanks

Top
#379752 - 12/29/13 07:00 AM Re: Help. S950 compressor for talk settings [Re: Beakybird]
Dnj Offline
Senior Member

Registered: 09/21/00
Posts: 43703
The compressor isn't going to help.....you need speaker stands for a better sound direction to the audience, I use them on every show plus it looks so much better, you could go with the Bose systems but that will be MONO........he headset mic imo isn't the best for singing too much noise coming from all angles vs a direct vocal good super cardoid polar pattern handheld like the EV 767 http://www.electrovoice.com/product.php?id=85 ..& I think it looks so much better for the performer vs a headset. Big pay or small the audience deserves the very best from the entertainer.

Top
#379765 - 12/29/13 08:01 AM Re: Help. S950 compressor for talk settings [Re: Dnj]
Beakybird Offline
Senior Member

Registered: 01/27/01
Posts: 2227
Originally Posted By: Dnj
The compressor isn't going to help.....you need speaker stands for a better sound direction to the audience, I use them on every show plus it looks so much better, you could go with the Bose systems but that will be MONO........he headset mic imo isn't the best for singing too much noise coming from all angles vs a direct vocal good super cardoid polar pattern handheld like the EV 767 http://www.electrovoice.com/product.php?id=85 ..& I think it looks so much better for the performer vs a headset. Big pay or small the audience deserves the very best from the entertainer.


Thanks for offering help.

Why wouldn't a compressor help? I get zero complaints about my sound system or my voice when I'm singing, but I get occasional complaints from individuals who cannot hear my speech in between songs. If there are cadences in my speech that these seniors cannot pick up because the volume is not consistent, a compressor would help.

So, I am not requesting assistance on what kind of mic to use, mic placement, speaker placement, or anything else.

Yamaha provides a compressor in the Talk settings. There must be a reason for this. My question is, what would be a good way to set the compressor to aid in clear speech. This is from someone who does not know what any of the controls are for.


Edited by Beakybird (12/29/13 08:04 AM)

Top
#379768 - 12/29/13 09:03 AM Re: Help. S950 compressor for talk settings [Re: Beakybird]
Dnj Offline
Senior Member

Registered: 09/21/00
Posts: 43703
Originally Posted By: Beakybird
Originally Posted By: Dnj
The compressor isn't going to help.....you need speaker stands for a better sound direction to the audience, I use them on every show plus it looks so much better, you could go with the Bose systems but that will be MONO........he headset mic imo isn't the best for singing too much noise coming from all angles vs a direct vocal good super cardoid polar pattern handheld like the EV 767 http://www.electrovoice.com/product.php?id=85 ..& I think it looks so much better for the performer vs a headset. Big pay or small the audience deserves the very best from the entertainer.


Thanks for offering help.

Why wouldn't a compressor help? I get zero complaints about my sound system or my voice when I'm singing, but I get occasional complaints from individuals who cannot hear my speech in between songs. If there are cadences in my speech that these seniors cannot pick up because the volume is not consistent, a compressor would help.

So, I am not requesting assistance on what kind of mic to use, mic placement, speaker placement, or anything else.

Yamaha provides a compressor in the Talk settings. There must be a reason for this. My question is, what would be a good way to set the compressor to aid in clear speech. This is from someone who does not know what any of the controls are for.


I would also consider that most audiences in a NH scenario have hearing difficulties and many times have problems hearing no matter what, hearing aides or what have you ......plus the fact that many jokes etc, go way over their head to comprehend especially one liner jokes due to their age...this might help also...good luck.

http://www.doctorproaudio.com/doctor/temas/dynamics-processors-compressors_en.shtml


Edited by Dnj (12/29/13 09:03 AM)

Top
#379770 - 12/29/13 09:18 AM Re: Help. S950 compressor for talk settings [Re: Beakybird]
billyhank Offline
Member

Registered: 09/07/12
Posts: 322
Yes in deed - hearing difficulties due to age.

Listening to music and singing is different than listening to plain speech. with music, if you can hear the melody, then you still can enjoy the song and having gone completely deaf once in my life, I can tell you that music was the last thing to go.

Bill G

Top
#379796 - 12/29/13 11:18 AM Re: Help. S950 compressor for talk settings [Re: Beakybird]
Diki Online   content


Registered: 04/25/05
Posts: 14268
Loc: NW Florida
Sorry, but it isn't THEIR hearing that is the problem!

Think about it for a minute... Most of us sing pretty strong. The mike and the monitoring is set up to be optimized for this. Then you use the SAME settings to talk into. And few of us talk as loudly as when we sing. Here's the problem.

TBH, the only way you can effectively overcome this is to talk a LOT louder and clearer than you normally do. It's called 'projecting' and is a standard technique for theater performers who aren't miked. A good actor will fill a theater with just his spoken voice, and not sound like he is shouting. But converse in their normal voice, only the first few rows will hear a thing.

Go and see most bands, solo performers, anyone with no soundman to ride the levels, and you will see that not being heard well while talking is a usual occurrence! The way to fix it is not with technology (all a compressor will do is boost gain when you talk quietly, which will usually mean a ton of feedback), but by working on learning to talk clearer and LOUDER! Understand that, when on stage, between numbers, you aren't having a conversation in your living room... You are in a theater, trying to project to the back seats!
_________________________
An arranger is just a tool. What matters is what you build with it..!

Top
#379840 - 12/29/13 04:25 PM Re: Help. S950 compressor for talk settings [Re: Diki]
Beakybird Offline
Senior Member

Registered: 01/27/01
Posts: 2227
Originally Posted By: Diki
Sorry, but it isn't THEIR hearing that is the problem!

Think about it for a minute... Most of us sing pretty strong. The mike and the monitoring is set up to be optimized for this. Then you use the SAME settings to talk into. And few of us talk as loudly as when we sing. Here's the problem.

TBH, the only way you can effectively overcome this is to talk a LOT louder and clearer than you normally do. It's called 'projecting' and is a standard technique for theater performers who aren't miked. A good actor will fill a theater with just his spoken voice, and not sound like he is shouting. But converse in their normal voice, only the first few rows will hear a thing.

Go and see most bands, solo performers, anyone with no soundman to ride the levels, and you will see that not being heard well while talking is a usual occurrence! The way to fix it is not with technology (all a compressor will do is boost gain when you talk quietly, which will usually mean a ton of feedback), but by working on learning to talk clearer and LOUDER! Understand that, when on stage, between numbers, you aren't having a conversation in your living room... You are in a theater, trying to project to the back seats!


Speaking more clearly can always help. That's for sure. But last night at my show, a lady on the left came up to me in between songs, and she said we hear you great when you're singing, but not when you're talking, so I tilted my speaker so it would face the left side of the room.

After the show, a section of six people to my left said that they could hear me speaking louder but they had the same difficulty understanding me. The folks in the front of the room were completely cracking up at my little one liners and jokes.

I was thinking that with a compressor, I could turn up the volume of my speaking voice but make it so that the volume is more consistent. I don't know, there must be a reason why they included a compressor in the talk settings menu. I've never had a problem with feedback coming from my mic.

Here's an article on using a compressor for a pastor at a place of worship. According to this writer, it helps a lot at making the voice more intelligible. http://www.ccisolutions.com/StoreFront/category/church-sound-systems-audio-compressors.

On the PSR-S950, there are just three knobs: Threshold, Ratio, and Out. Most compressors don't have OUT. They have an output gain knob for -20db to +20db output gain. This compressor has an OUT knob with 0-127 as parameters.

Also in the TALK settings menu under TALK MIXING there is a volume slider and a reduction level slider. What is the reduction level slider for if there's already a volume knob?

Top
#379842 - 12/29/13 04:59 PM Re: Help. S950 compressor for talk settings [Re: Beakybird]
Dnj Offline
Senior Member

Registered: 09/21/00
Posts: 43703
Turn settings while you talk and see what sounds best to your ears.


Edited by Dnj (12/29/13 05:25 PM)

Top
Page 1 of 3 1 2 3 >

Moderator:  Admin, Diki, Kerry 



Help keep Synth Zone Online