|
|
|
|
|
|
#279728 - 01/21/10 02:14 PM
Re: BA330 and Bose Compact..tested today
|
Senior Member
Registered: 11/24/99
Posts: 1675
Loc: Milford, CT, USA
|
I've sold allot of the italian made stuff, the FBT and RCF, they are great. The key is the musicality of the more premier stuff. Yes you can buy a powered speaker from another company for under $300 that has great looking specs, 400 watts, 40 - 20k response,. But if you look into it, it's 400 watts max, 100 nominal, the response is +/- 10db which is horrible. Especially when you push the volume that where the cheaper stuff falls apart, you get mechanical compression from the cheaper drivers, tolerances that change because of the cheaper components. In the end it's all about the sound and relaibility. If your spending the money that's the way to go. but you will always get what you pay for.' if it seems too good to be true then it usually is ------------------ www.AudioworksCT.com
|
Top
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
#279733 - 01/22/10 11:12 AM
Re: BA330 and Bose Compact..tested today
|
Senior Member
Registered: 09/23/05
Posts: 1002
Loc: Phila. 'burbs, Pa. USA
|
Thanks Fran for the info, and before we get too far away from one of your initial elucidations, I have a couple of questions about the M-10X and Bose Compact combo. Please bare with me as I am not a tech head … I have the Bose L1 that I use with a B1 for large (mostly ourdoor) venues. With the Bose remote, I can pretty easily get the sound I want from the L1. For other venues, I use the Bose Compact and you are spot on about the lack of some of the low-mid range. I have used a couple of different mixers and have either over compensated or get a muddy bottom. So, if I understand, what you’re saying is that this Edirol mixer can analyze the venue’s acoustics and automatically EQ itself to match the room’s acoustics?? If that’s the case, can this feature be accessed on the fly? For example, I set up for my restaurant gig and do a sound check with the room fairly empty, a little while later, the room fills and the acoustics dramatically change – I just push a button and it compensates ?? I assume that effects can be assigned to individual channels – reverb for the mic, no FX for the module etc.? I would think that the Bose T-1 would pretty much be able to zero in on the missing frequencies, but if the Edirol does this automatically, and is nearly $400 less … duh … so there may be a little 'hiss', if it's the same frequency range as my tinnitus - I won't notice. Ciao, Jerry
[This message has been edited by Jerry T (edited 01-22-2010).]
|
Top
|
|
|
|
|
|
|
|
|
|
|
|
|