Like on the muted trumpets and harmonicas? I can make the modulation part of the joystick do filter changes, but I want a filter change to occur with a pitch bend, moving it from left to right rather than pushing it forward.

Thanks
Rory

you can't

If I can't, then who can? As I said, it exists on one of the muted trumpet patches and a couple of the harmonica patches. So, if it is happening on the factory presets, there must be a way to edit this yourself.

strange, I didn't think it was possible...
well, I guess I'll have a look at it

you were right!
patch PR-C:001 Harmon Mute uses this

Select the patch, press LFO&Ctl (F5) then press Control (F3)

Number 3 is set to pitch bend -> CUT: +20
So cutoff will increase by 20 if you pitch up and decrease by 20 if you pitch down.

It's a bit confusing because there is another "Control" menu under "Common" (F1).

and if you go to "Ctrl Switch" (F4) in the LFO&Ctl menu you can even disable pitch bending so you can use the pitch bend stick for the filter only!

So can you use the pitch bend for anything? Volumes, pans, etc?

well not everything... pitch, cutoff, resonance, level, pan, some LFO settings and a few others

Awesome! Thank you. I wonder why there are not more patches using the pitch bend in this way? It's like having another realtime controller.