I'm using midifiles. and I'm using the vocalizer occasionally. The manual suggests to activate the vocalizer by controller 16=0. Works fine, but there seems to be no controller to reset the part back to "voice". I assume there is one, but it is nowhere documented, and the hotline knows nothing about it. I'm using a sysex message so far, but a controller would be a lot easier to handle. (Should be the same with SD1 or X1)
Robert

[This message has been edited by Robbe52 (edited 07-27-2008).]

Controller 16=F0

Hello AJ,
I don't grab it. controller 16 is a controller-event 16 (dec), value 0, the part is set to "vocalizer"; in my case the track with channel 14. Works, display shows ""vocalizer". But how can I reset the part mode to "voice" by a controller event? "F0" is hex, and 240(dec) is not feasible.
Robert

[This message has been edited by Robbe52 (edited 07-29-2008).]

[This message has been edited by Robbe52 (edited 07-29-2008).]