When I reformated my hard drive, I lost the Technics Copy Program, and the link provided in this forum does not seem to be working properly at this time.

( This is the small shareware program that allows auto numbering of Technics files to be copied. )

Therefore, can someone please direct me to another download site, or perhaps email me the program if possible.

Thanks Gang !

Larry Hawk

Oh yes, while I'm at it, I have another request.

I have looked all over the Internet for the sheet music for "I'm Drinking Champagne", (or is it "Drinking Champagne")

Either one I cannot find. It is a pretty song made by George Strait a while back, and perhaps someone before that.

...I'm Drinking Champage
Fellin' No Pain
Till The Early Mornin'...

Thanks Once Again
Larry Hawk

Larry,
Technic copy program in your email in a few minutes,
Bebop

Hi Larry, Try this site:
http://www.cowboylyric.com/tabs/strait-george/drinking-champagne.1726.html
Dick

jrw, thanks..that is a real nice site, but unfortunatly, there is no sheet music available.

Bb..thanks for sending the Technics Copy Program.

Larry

Hi Larry

You'll find the sheet music (in album form with 9 other songs) at: http://www.stagepass.com/groupartist/artist_item_detail.hperl?Artist=Strait%2C+George&Invnum=308141

John

What do you mean with Technics Copy program. I only know Song Manager and Audio Recorder that came with the keyboard.

Fred - this copy program allows you to copy across files and it then renumbers the first two digits. e.g. if you have two technics styles which have been saved on different floppies and just both happened been saved to each floppy as 02 prefix. If you copied both these to one disk then the keyboard would only read one of them.
You would normally have to renumber the first two digits to stop this happening. As there could be 6 items in each style this is very laborious. this program helps you around this. Joan

OK, so when having our KN-SDExplorer tool, we don't have to worry and even use 16 characters without necessary 2 digits on the SD-Card: better intuitive naming.

But is the Technics Copy Program really a Technics program? I have never heard of it. I was thinking if it is just a little "rename utility" like Flash Renamer.

But anyway I have Fred's great tool and it takes care of all this

Kenneth
www.KN7000.net

[This message has been edited by Kenneth Gundersen (edited 02-10-2005).]