Is it possible to increase the amplitude for the drawbars on the KN7000 other than altering the vertual drawbar sliders? I find the sound is very weak compared with other instrument sounds which one can edit.
Derek

Hi Derek,
I don’t know if you have solved your problem yet with the Digital Drawbars?

The way I increase the Volume is, once I have got the sound I want, I save it
in Panel Memory 1to8.
then go to Sound DSP button and press until Sound DSP displays in the window.

Then find Rotary Speaker in the centre column, and select Mellow Twin.

Then select Edit in the bottom left corner and press. Window then displays
Effect Edit, the right hand side, displays Parameter & Value. Under Parameter,
you have Drive. Value should be at (0) increase Value, and the Volume of your
Digital Drawbars should increase, to what you want.

Press write in the bottom left hand corner and Mellow Twin will be saved in
Effect Memory List {1}.

Press exit once and windows displays Sound DSP. In the Effects column,
Run through to the last one, which is Effect Memory, and in the top left hand corner you should see Mellow Twin. Select it and save in Panel Memory 1 to 8.

If you want to adjust the volume further press edit in the bottom left hand corner,
The window displays Effect Edit, increase the volume, press write, then save to
Panel Memory.

If you press Digital Drawbar, you can then adjust the Sound, then save to Panel Memory.

Then save to S.D. card.

There may be an easier way of doing it.
I hope it helps.

Fred Wren.

Hi Fred, Thank you for your advice about the above. I'll give it a whirl next time I'm on the KN7000.
Derek