Hi All,

Regarding Factory Setup, I loaded the factory setup, and all got loaded well.

I attempted to load my pervious setup from SD card, and I observed that the Memory panel did not get loaded.

I checked to see the panel memory is checked to be loaded.

Any thoughts?

Best regards,
Doron

Hi Doron,

Try this:-

Press and hold the blue button in centre of Panel Memories wheel, until Panel Memory Mode is shown on screen. Make sure EXPAND is high-lighted, then go to page 2 and check that all the Filters are ON. Then load your SD Card again. If this load is successful, you should go through procedure as before just to check that the settings have changed to those you had on your SD Card. If they have, BINGO you've been successful.

Good luck!

Audrey

Thanks Audrey for the prompt reply.

I am going to apply your advices.

Many thanks,
Doron

Hi,

I tried it, and I get the same results.

Filter on, does it mean allow the date to be overwritten?

Many thanks,
Doron