Hello,
Your email address has denied the acceptance of my e-mail.
So, I write it into the forum.
It is difficult for me in a foreign language professional terms to describe. I hope you can understand my attempt.
Installation instructions for update KN2600
1. Current version:
- Turn off the keyboard.
- Press the SOUND GROUP section the first three buttons in the top row
[PIANO] - [STRINGS & VOCAL] - [GUITAR & HARPSI] and keep them during the
Switching mode.
- After turning right you will see below in the display
Version number.
- If the version number is equal to or even higher, than those offered here,
an update is not necessary.
2. Create the update on a SD-Card
- Use the update is only for SD cards from 8 to 64 MB
Storage capacity. The SD card has been formatted at the keyboard (not
on the PC).
- Insert the SD card into your SD card writer, and make sure
that this computer is connected.
- Now copy the file "KN24PRG.DAT" on the SD Card.
3. The update on KN2600:
- Insert the SD Card into the SD slot of your KN2600 On.
- Press the first 4 panel memory keys, hold it down and
turn on the Keyboard.
- Select the display UPDATE so often, until the process begins.
- When the message "Completed! Turn on AGAIN" turn off your KN2600 and
after about 2-3 seconds.
CA Software assumes no responsibility for errors or
Damage caused by the update! Do take the precaution at the point 3 in
described process instead of "UPDATE" First, a "CHECK".
Greetings
Harry
Previous Topic
Index