SYNTH ZONE
Visit The Bar For Casual Discussion
Page 1 of 2 1 2 >
Topic Options
#90938 - 06/13/03 06:25 PM HELP I need a P/C Geru .................
Dnj Offline
Senior Member

Registered: 09/21/00
Posts: 43703
Can anyone help me….I just rehooked my pc in my new house …..all is well to get on line etc etc BUT I cannot hear any midis….or mp3’s…I get an message saying no audio sound sorce is detected check device manager which I did and it shows an
“Explanation Mark” next to PCI Multimedia Device….Also I noticed there is no
"SPEAKER ICON" on the lower tool bar either????I know I have a sound card installed. What can I do? HELPPPPPP!!!!


[This message has been edited by Dnj (edited 06-13-2003).]

Top
#90939 - 06/13/03 06:47 PM Re: HELP I need a P/C Geru .................
DonM Offline
Senior Member

Registered: 06/25/99
Posts: 16735
Loc: Benton, LA, USA
Donny if you're still there call me and I'll try to help.
DonM
_________________________
DonM

Top
#90940 - 06/13/03 06:49 PM Re: HELP I need a P/C Geru .................
travlin'easy Offline
Senior Member

Registered: 12/08/02
Posts: 15576
Loc: Forest Hill, MD USA
Donny,

That exclamation mark is an indicator that there is a conflict with another device. There are a few things I need to know in order to help.

1. Which version of windows are you running?
2. Is your sound card an onboard card, or is it separate from the mother board?
3. If it's separate, there's a chance that it is loose from the socket, and therefore, the computer cannot detect it.
4. If the card is a plug and play, and assuming it is not defective, merely uninstall the sound card using the control panel, then turn off the computer, remove the card and reboot. Shut the computer down again, re-install the sound card and reboot. Your computer should find the sound card and re-install it with different settings so there is no conflict.

Hope this helps! If not, I'll drive up next week, bring a couple dozen crabs, a case of beer, a bottle of Kahlua and try to figure it out.

Gary
_________________________
PSR-S950, TC Helicon Harmony-M, Digitech VR, Samson Q7, Sennheiser E855, Custom Console, and lots of other silly stuff!

K+E=W (Knowledge Plus Experience = Wisdom.)

Top
#90941 - 06/13/03 07:01 PM Re: HELP I need a P/C Geru .................
DonM Offline
Senior Member

Registered: 06/25/99
Posts: 16735
Loc: Benton, LA, USA
Gary, great minds think alike. I just told Donny the same thing on the phone!
DonM
_________________________
DonM

Top
#90942 - 06/13/03 07:31 PM Re: HELP I need a P/C Geru .................
Dnj Offline
Senior Member

Registered: 09/21/00
Posts: 43703
ok ......I just took off the cover and checked the sound card for a loose connection....its seems to be in the socket properly and tight.....
Then I started the pc again but I get a blue screen on start up that reads.....

"The SBPCI interrupt has been routed incorrectly by the system use the automatic settings in the device manager"

now what?



[This message has been edited by Dnj (edited 06-13-2003).]

[This message has been edited by Dnj (edited 06-13-2003).]

Top
#90943 - 06/13/03 07:38 PM Re: HELP I need a P/C Geru .................
DonM Offline
Senior Member

Registered: 06/25/99
Posts: 16735
Loc: Benton, LA, USA
Well, at least the computer found the card!
Have you installed anything else lately?
I would remove the card, then reboot. Since it won't see the card, there shouldn't be an interupt request conflict.
If so, then reinstall the card and see if the computer assigns it to the correct channel this time.
DonM
_________________________
DonM

Top
#90944 - 06/13/03 08:13 PM Re: HELP I need a P/C Geru .................
travlin'easy Offline
Senior Member

Registered: 12/08/02
Posts: 15576
Loc: Forest Hill, MD USA
Ditto!

Gary
_________________________
PSR-S950, TC Helicon Harmony-M, Digitech VR, Samson Q7, Sennheiser E855, Custom Console, and lots of other silly stuff!

K+E=W (Knowledge Plus Experience = Wisdom.)

Top
#90945 - 06/13/03 08:36 PM Re: HELP I need a P/C Geru .................
DonM Offline
Senior Member

Registered: 06/25/99
Posts: 16735
Loc: Benton, LA, USA
O.K. Donny? Donny? Anyone? Anyone?
Don
_________________________
DonM

Top
#90946 - 06/14/03 03:15 AM Re: HELP I need a P/C Geru .................
Nigel Offline
Admin

Registered: 06/01/98
Posts: 6483
Loc: Ventura CA USA
And if removing and replacing the card doesn't make the system reallocate an unused interrupt then you can always try removing the hardware device entry in the Hardware Device Manager and try reinstalling. Though there is no reason that a card that was previously working with its assigned IRQ should suddenly have problems. But installing another device could cause this sort of a problem if you have run out of available IRQs. You can check IRQ conflicts & sharing ( which is valid in some cases ) by going to Start - Programs - Accessories and running the System Info utility which will list what is using the IRQs, so look there to see what is trying to use the same IRQ as your soundcard. It may at least pinpoint the source of the problem.


[This message has been edited by Nigel (edited 06-14-2003).]

Top
#90947 - 06/14/03 04:09 AM Re: HELP I need a P/C Geru .................
Dnj Offline
Senior Member

Registered: 09/21/00
Posts: 43703
Nigel I checked and this is what turns up......how can I installl the drivers again? anyone?

[Creative Sound Blaster AudioPCI 128
MEDIA
This Device Has a Problem: Code=10 (0xA)
This device is not present, not working properly, or does not have all the
drivers installed. See your hardware documentation.
Registry Key: HKEY_LOCAL_MACHINE\enum\PCI\VEN_1274&DEV_1371&SUBSYS_13711274&REV_06\BUS_00&DEV_0B&FUNC_00
Alloc resources: Logical Configuration 0
IRQ: 10 Mask: xFFFF
IO Range: Base=x1040 End=x107F Min=x0000 Max=xFFFF Alias=xFF, Decode=x00
Forced resources: None
Boot resources: None
Filtered resources: Logical Configuration 0
IRQ: 10 Mask: xFFFF
IO Range: Base=x1040 End=x107F Min=x0000 Max=xFFFF Alias=xFF, Decode=x00
Basic resources: Logical Configuration 0
IRQ: 0 Mask: xFFFF
IO Range: Base=xB400 End=xB43F Min=x0000 Max=xFFFF Alias=xFF, Decode=x00
HW Revision: 006
Driver: MEDIA\0000
Driver Date: 3-31-2000
Driver: ensqio.vxd
File Size: 23727 (0x5CAF)
File Date: 7/15/1999 12:50 PM
Company Name: Creative Technology Ltd.]

Top
Page 1 of 2 1 2 >

Moderator:  Admin, Diki, Kerry 



Help keep Synth Zone Online