SYNTH ZONE
Visit The Bar For Casual Discussion
Topic Options
#214500 - 05/26/05 07:35 AM Vocal Harmony balance, psr2000
SemiLiveMusic Offline
Senior Member

Registered: 08/28/04
Posts: 2206
Loc: Louisiana, USA
Anyone know... I have it set as...

Vocal Harmony setting = L35>H

I think the Harmony vocal is too prominent in the mix and I want LESS harmony. Which is which? How do I reduce harmony vocal? I read the manual and it's unclear.
_________________________
~ ~ ~
Bill

Top
#214501 - 05/26/05 08:12 AM Re: Vocal Harmony balance, psr2000
DonM Offline
Senior Member

Registered: 06/25/99
Posts: 16735
Loc: Benton, LA, USA
The L if for Lead, the H is for Harmony.
You have L 35 greater than H.
I think I set the Lead at 60, or whatever is full volume. Don't recall the actual way to set it, but it was easy in the microphone settings page.
DonM
_________________________
DonM

Top
#214502 - 05/26/05 10:10 AM Re: Vocal Harmony balance, psr2000
travlin'easy Offline
Senior Member

Registered: 12/08/02
Posts: 15576
Loc: Forest Hill, MD USA
Bill,

Without the keyboard in front of me I have a tough time remembering the procedure for the 2000. However, you must go into the mic seting/vocal harmony screen, then select mic setting. At the bottom of the screen, you will see a knob the is labled BAL. and beneath it is L=H. Press the bottom of the #4 button at the bottom of the display screen, then using the scrolling wheel turn it till the reading is L35>H. This means the lead is 35 percent higher than the harmony. If you want less harmony, adjust the L reading to a higher figure. The maximum is 63, which means you would have just 37 percent harmony, which is very low. Save this information to a registration, be sure the mic box is checked in the registration settings memory box, then it can be recalled.

Gary

Gary
_________________________
PSR-S950, TC Helicon Harmony-M, Digitech VR, Samson Q7, Sennheiser E855, Custom Console, and lots of other silly stuff!

K+E=W (Knowledge Plus Experience = Wisdom.)

Top
#214503 - 05/26/05 11:09 AM Re: Vocal Harmony balance, psr2000
SemiLiveMusic Offline
Senior Member

Registered: 08/28/04
Posts: 2206
Loc: Louisiana, USA
Yes, I found out HOW to make the change, I just wasn't sure which way to go with it. I assumed it meant I should make the number higher.

Gary, if you read this again... the Reg I have called "Setup," that is what I push when I first turn on the keyboard. To make it like I want it (changing vocal harmony)... is this right?

1. Turn on keyboard.
2. Push button for registration called "Setup."
3. Make vocal harmony change that I want, such as make it L45>H.
4. Save the registation again as "Setup."

In other words, I want to continue to use the Registration settings we did for the "Setup" button, except I want to increase the lead vocal part.
_________________________
~ ~ ~
Bill

Top
#214504 - 05/26/05 12:05 PM Re: Vocal Harmony balance, psr2000
travlin'easy Offline
Senior Member

Registered: 12/08/02
Posts: 15576
Loc: Forest Hill, MD USA
You've got it Bill. I have a few minutes before loading up the gear for this evening's job, then gotta put on a tux and try to look pretty. Hmmmmmmmm! Might take more than a tux to accomplish this--better talk with Miss Clairol too.

Gary
_________________________
PSR-S950, TC Helicon Harmony-M, Digitech VR, Samson Q7, Sennheiser E855, Custom Console, and lots of other silly stuff!

K+E=W (Knowledge Plus Experience = Wisdom.)

Top

Moderator:  Admin, Diki, Kerry 



Help keep Synth Zone Online